Olympus BondMaster 600 - Figure 6-5 the Recommended GATE Position

DMTA-10045-01EN, Rev. E, August 2016
Chapter 6 126
Figure 6‑5 The recommended GATE position
IMPULSE display
IMPULSE mode applies an envelope filter over the RF signal. (The name “IMPULSE”
originates from earlier BondMaster products.)
6. If preferred, set the RF DISPLAY (E key) to IMPULSE (see Figure 6-6 on
page 127). However, it is recommended to use the RF DISPLAY mode because it
allows easier interpretation of each signal oscillation.
NOTE