Olympus BondMaster 600 - Adjusting Auto Erase

DMTA-10045-01EN, Rev. E, August 2016
Chapter 4 66
display brightness is set to 50 %. The transflective color display of the BondMaster 600
reflects ambient light and becomes brighter in direct light. With brighter ambient
conditions, you can set the display BRIGHTNESS to a lower percentage.
To change the display brightness
1. Press ADV SETUP twice, then press the B key to enter the SYSTEM SETUP
screen and press FULL NEXT until BRIGHTNESS is highlighted.
2. Using the knob, select the desired BRIGHTNESS percentage: 0%, 25 %, 50 %,
75 %, or 100 %.
3. Press to return to the main inspection screen.
Reducing the display BRIGHTNESS percentage increases the battery life. Battery life
specifications are based on backlight BRIGHTNESS set to 50 %.
4.5 Adjusting Auto Erase
You can adjust the BondMaster 600 to clear (erase) the screen contents automatically
after the CAL NULL key ( ) is pressed. By default, the AUTO ERASE is set to ON,
but it can be disabled by selecting OFF.
To adjust Auto Erase
1. Press the ADV SETUP menu key ( ) twice, then press the B key to enter the
SYSTEM SETUP screen and press the FULL NEXT key ( ) until AUTO ERASE
is highlighted.
2. Use the knob to disable (select OFF) or enable (select ON) the AUTO ERASE.
3. Press to return to the main inspection screen.
NOTE