DMTA-10045-01EN, Rev. E, August 2016
Initial Setup
67
4.6 Selecting the Startup Screen
You can adjust the BondMaster 600 to automatically display the
APPLICATION MENU screen after it is turned on. This function can also be disabled,
so that the BondMaster 600 will instead display the main inspection screen. By
default, the APPLICATION WINDOW AT STARTUP function is set to ON.
To select the startup screen
1. Press the ADV SETUP menu key ( ) twice, then press the B key to enter the
SYSTEM SETUP screen and press the FULL NEXT key ( ) until
APPLICATION WINDOW AT STARTUP is highlighted.
2. Use the knob to disable (select OFF) or enable (select ON) this function.
3. Press to return to the main inspection screen.
4.7 Activating the Crosshairs
You can set the BondMaster 600 to display crosshairs to better highlight the position
of the null (see Figure 4-2 on page 68). Crosshairs are available only for XY screens
(with or without split screen), but functions in ALL modes.
To activate the crosshairs function
1. Press the ADV SETUP menu key ( ) twice, then press the B key to enter the
SYSTEM SETUP screen and press the FULL NEXT key ( ) until
CROSSHAIRS is highlighted.
2. Use the knob to disable (select OFF) or enable (select ON) the CROSSHAIRS.
3. Press to return to the main inspection screen.
To Next Page
Loading...
