DMTA-10045-01EN, Rev. E, August 2016
Chapter 2
30
The BondMaster 600 charger/adaptor (P/N: EP-MCA-X) is designed to power the
BondMaster 600 and charge the lithium-ion battery only (P/N: 600-BAT-L-2
[U8760058]).
Do not attempt to charge any other types of batteries, including alkaline batteries in
the battery holder (P/N: 600-BAT-AA [U8780295]), and do not attempt to use any
other charger/adaptor. Doing so might cause an explosion or injury. Do not attempt to
power or charge other electronic equipment with the charger/adaptor (P/N:
EP-MCA-X), unless specifically instructed in the manual. Misuse of the
charger/adaptor can cause other batteries and/or instruments to explode, which could
lead to serious injury or death.
To connect the charger/adaptor
1. Connect the AC power cord to the charger/adaptor and to an appropriate power
outlet (see Figure 2-7 on page 30).
Figure 2‑7 Connecting the charger/adaptor
To power outlet
DC power connector
EP-MCA-X
charger/adaptor
AC power cord
To Next Page
Loading...
