Raisecom iTN2100 - DIP Switches; Table 15-36 Configurations of DIP Switch SW2 on the OPCOM3500 E-120 FE× 4-GE

Raisecom
iTN2100 (P100R002) Hardware Description
15 PDH and RCMS cards
Raisecom Technology Co., Ltd.
165
Interface
Status
Description
FDX
Green
Duplex mode LED

Green: the Ethernet interface is working in full duplex mode.

Off: the Ethernet interface is working in half duplex mode.
LNK/ACT
Green
Ethernet interface working LED

Green: the Ethernet interface is properly connected.

Off: the Ethernet interface is improperly connected or
disconnected.

Blinking green: the Ethernet interface is receiving or sending
data.
100M
Green
Ethernet interface 100 Mbit/s rate LED

Green: the interface is working at 100 Mbit/s.

Off: the interface is not working at 100 Mbit/s.
1000M
Green
Ethernet interface 1000 Mbit/s rate LED

Green: the interface is working at 1000 Mbit/s.

Off: the interface is not working at 1000 Mbit/s.
LPR (A–D)
Red
Interface A/B/C/D remote device LPR alarm LED

Red: after the local device and the remote device connected to
interface A, B, C, or D are connected and work properly, LPR
occurs on the remote device.

Off: the remote device connected to interface A, B, C, or D is
working properly.
LOS (A–D)
Red
Interface A/B/C/D LOS alarm LED

Red: input LOS alarms are generated on interface A, B, C, or
D.

Off: no input LOS alarms are generated on interface A, B, C,
or D.

Blinking green: input LOS alarms are generated on the remote
device connected to interface A, B, C, or D.
15.7.5 DIP switches
The OPCOM3500E-120FE×4-GE has three DIP switches: SW2, SW3, and SW4, as listed in
Table 15-36, Table 15-37 and Table 15-38.
Table 15-36 Configurations of DIP switch SW2 on the OPCOM3500E-120FE×4-GE
DIP
switch
Function
Status
Description
Bit1
Bit2
Bit3
Bit4
Optical interface
device
SW2
Set the type
of the
optical
interface
device.
ON
ON
ON
ON
M
ON
ON
ON
OFF
S1
ON
ON
OFF
ON
S2
ON
ON
OFF
OFF
S3