Parameter Description Range of values / note
auto-logout Shows the configuration settings of the
auto logout function
-
time Shows the configuration settings of the
system time
-
ntp Shows the configuration settings of the
Network Time Protocol
-
auto-save Shows the configuration settings of the
auto save function
-
panel-button Shows the configuration settings of the
Panel Button function
-
cos-map Shows the configuration settings of the
COS function
-
dscp-map Shows the configuration settings of the
DSCP map function
-
output-rate-limit Shows the configuration settings of the
output rate limit function
-
unicast-blocking Shows the configuration settings of the
unicast blocking
-
ospf Shows the configuration settings of the
Open Shortest Path First
-
vrrp Shows the configuration settings of the
Virtual Router Redundancy Protocol
-
loopd Shows the configuration settings of loop
detection
-
events Shows the configuration settings of the
events
-
redundancy Shows the configuration settings of the
redundancy
-
passive Shows the configuration settings of pas‐
sive listening
-
umac Shows the configuration settings of the
user configuration
-
nat Shows the configuration settings of the
Network Address Translation
-
fmp Shows the configuration settings of the
Fiber Monitoring protocol
-
pim Shows the configuration settings of the
Independent Multicast protocol
-
router-
advertisement-
blocking
Shows the configuration settings of the
router advertisement blocking.
-
all shows all configuration settings and all
default parameters. Some parameters
cannot be changed.
-
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Configuration
3.4 Configuration Save & Restore
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
106 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
