Syntax
Call the command without parameter assignment:
multicast-block
Result
Multicast frames are blocked.
Further notes
You disable the blocking of multicast frames with the no multicast-block command.
3.1.10.11 no multicast-block
Description
With this command, you disable the blocking of multicast frames on an interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no multicast-block
Result
The blocking of multicast frames is disabled.
Further notes
You enable the blocking of multicast frames with the mulitcast-block command.
3.1.10.12 negotiation
Description
With this command, you enable autonegotiation of connection parameters on an interface.
Autonegotiation must be set for every interface of connected interfaces.
Configuration
3.1 System
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
84 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General