Result
The SNMP agent function is disabled.
Further notes
You enable the SNMP agent function with the snmpagent command.
7.5.2.3 snmp agent version
Description
With this command, you configure whether all SNMP queries or only SNMPv3 queries are
processed.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp agent version {v3only|all}
The parameters have the following meaning:
Parameter Description Range of values / note
v3only Only SNMPv3 queries are processed -
all All SNMP queries are processed Default: all
Result
The setting is configured.
7.5.2.4 snmp access
Description
With this command, you configure the access to an SNMP group.
Requirement
You are in the Global configuration mode.
Network protocols
7.5 SNMP
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 331
To Next Page
Loading...
