You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
3.4.3.1 auto-save
Description
The CLI can save changes to the configuration automatically.
If you first want to test changes made to the configuration so that you can discard them
afterwards if necessary, you can disable the auto save function.
You are then in the Trial mode.
Changes to the configuration that you have not saved, are indicated by an asterisk in front of
the command prompt: *cli(...)#.
You save the changes to the configuration with the write startup-config command.
With the auto-save command, you enable the auto save function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
auto-save
As default the function is "enabled".
Result
The auto save function is enabled.
Further notes
You save changes to the configuration in the Trial mode with the write startup-config
command.
You disable the function with the no auto-save command.
You can display the status of this function and other information with the show device
informationcommand.
Configuration
3.4 Configuration Save & Restore
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
108 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General