Siemens SCALANCE XR-300WG - No Switchport Private-Vlan Mapping

Parameter Description Range of values / note
remove Removes secondary PVLANs. -
secondary_vlan_li
st
VLAN ID of the secondary PVLAN 1 ... 4094
Separate the PVLANs with
commas if you specify sev‐
eral PVLANs.
Result
The interface is configured.
Further notes
You delete the configuration with the no switchport private-vlan mapping command.
You display this setting and other information with the commands show vlan port
config, show vlan and show vlan private-vlan.
You configure the interface as a promiscuous port with the switchport mode command.
6.1.3.15 no switchport private-vlan mapping
Description
With this command, you delete the configuration of a promiscuous port.
Requirement
● The interface is configured as a promiscuous port.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no switchport private-vlan mapping
Result
The configuration is deleted.
Further notes
You configure a promiscuous port with the switchport private-vlan mapping
command.
Network structures
6.1 VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
190 Configuration Manual, 07/2017, C79000-G8976-C361-06