Siemens SCALANCE XR-300WG - General CLI Commands; Clear Screen; End

2.9 General CLI commands
This section describes commands that you can call up in any mode.
2.9.1 clear screen
Description
With this command, you clear the screen.
The command prompt is displayed.
Syntax
Call the command without parameters:
clear screen
Result
The screen is cleared.
The command prompt is displayed.
2.9.2 end
Description
With this command, you exit the configuration mode and are then in the Privileged EXEC mode.
Requirement
You are in a configuration mode.
Syntax
Call the command without parameters:
end
Result
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
General information
2.9 General CLI commands
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 39