3.1.1.8 show interfaces
Description
This command shows the status and the configuration of one, several or all interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show interfaces
[{
[<interface-type><interface-id>]
[{description|stormcontrol|flowcontrol|status}]
|
{vlan<vlan-id(1-4094)>}
|
port-channel<port-channel-id(1-8)>
}]
The parameters have the following meaning:
Parameter Description Range of values / note
interface-type Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
description Shows the description of the interface -
stormcontrol Shows the storm control settings -
flowcontrol Shows the flow control settings -
status Shows the status of the interface -
vlan Keyword for a VLAN connection -
vlan-id Number of the addressed VLAN 1 ... 4094
port-channel Keyword for a port channel connection -
port-channel-id Number of the addressed port channel 1 ... 8
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameters from the parameter list, the status and configuration of all
available interfaces will be displayed.
Configuration
3.1 System
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
52 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General