Siemens SCALANCE XR-300WG - Dot1 X Mac-Auth

Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no dot1x guest-vlan
Result
The guest VLAN function is disabled for the device.
Further notes
You enable the function with the dot1x guest-vlan. command
You display this setting and other information with the show dot1x command.
11.5.2.3 dot1x mac-auth
Description
With this command, you enable MAC authentication for the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
dot1x mac-auth
Result
MAC authentication is enabled for the device.
Security and authentication
11.5 Port Based Network Access Control
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 527