EasyManua.ls Logo

Siemens SCALANCE XR-300WG - Switchport Acceptable-Frame-Type

Siemens SCALANCE XR-300WG
618 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Syntax
Call the command without parameter assignment:
no private-vlan mapping
Result
The IP interface of the primary PVLAN cannot be reached from the selected secondary
PVLANs.
Further notes
You configure a link between secondary PVLANs and the IP interface of the primary PVLAN
with the command private-vlan mapping.
You display this setting with the show interfaces command with the private-vlan
mapping parameter.
6.1.3.3 switchport acceptable-frame-type
Description
With this command, you configure which types of frames are accepted.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport acceptable-frame-type{all|tagged|
untaggedAndPrioritytagged}
The parameters have the following meaning:
Parameter Description Range of values / note
all All frames are accepted. Default
On a ring port only the parameter
"all" is supported.
tagged The device discards all untagged
frames. The device forwards all tagged
frames.
-
untaggedAndPriori
tytagged
The device discards all tagged frames.
The device forwards all untagged
frames and frames with a priority.
-
Network structures
6.1 VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
180 Configuration Manual, 07/2017, C79000-G8976-C361-06

Table of Contents

Related product manuals