EasyManua.ls Logo

Siemens SCALANCE XR-300WG - Poe Type

Siemens SCALANCE XR-300WG
618 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Requirement
You are in the Interface Configuration mode of a PoE interface.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no poe custom maxpwr active
Result
The user-defined maximum power is disabled for the relevant interface.
Further notes
You configure the user-defined maximum power for an interface with the poe custom
maxpwr command.
You enable the use of the user-defined maximum power with the poe custom maxpwr
active command.
3.5.3.7 poe type
Description
This command specifies a character string that describes a connected device in greater detail.
Requirement
You are in the Interface configuration mode of a PoE interface.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
poe type <string>
The parameters have the following meaning:
Parameter Description Range of values / note
string Description of a connected device max. 255 characters
Configuration
3.5 PoE
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 117

Table of Contents

Related product manuals