Siemens SCALANCE XR-300WG - No Rate-Limit Output; Storm-Control

Further notes
You disable the function with the no rate-limit output command.
10.1.2.2 no rate-limit output
Description
With this command, you disable the data rate for limiting the outgoing data stream of the
interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no rate-limit output
Result
The limitation of the outgoing data stream of the interface with the data rate is disabled.
Further notes
You enable the function with the rate-limit output command.
10.1.2.3 storm-control
Description
With this command, you enable data rate for limiting the incoming data stream of the interface
for broadcast, multicast or unknown unicast packets.
Note
Applications
Storm control is only supported on physical interfaces.
Load control
10.1 Rate control
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
456 Configuration Manual, 07/2017, C79000-G8976-C361-06