EasyManuals Logo

Siemens SCALANCE XR-300WG User Manual

Siemens SCALANCE XR-300WG
618 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #532 background imageLoading...
Page #532 background image
Further notes
You configure the guest VLAN ID with the dot1x guest-vlan vlan-id command.
You display this setting and other information with the show dot1x command.
11.5.3.5 dot1x guest-vlan reset
Description
This command removes MAC addresses from the guest VLAN. If you specify a MAC address,
only this MAC address is removed from the guest VLAN. If you use this command without
parameters, all MAC addresses are removed from the guest VLAN.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
dot1x guest-vlan reset [mac <aa:aa:aa:aa:aa:aa>]
The parameter has the following meaning:
Parameter Description Range of values / note
mac Keyword for the MAC address -
MAC address to be removed from the
guest VLAN.
aa:aa:aa:aa:aa:aa
Result
The specified MAC address or all MAC addresses are no longer assigned to the guest VLAN.
11.5.3.6 set dot1x guest-vlan mac-addr count
Description
With this command, you specify how many MAC addresses can be authenticated on the port
at the same time.
Requirement
You are in the Interface configuration mode.
Security and authentication
11.5 Port Based Network Access Control
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
532 Configuration Manual, 07/2017, C79000-G8976-C361-06

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SCALANCE XR-300WG and is the answer not in the manual?

Siemens SCALANCE XR-300WG Specifications

General IconGeneral
BrandSiemens
ModelSCALANCE XR-300WG
CategorySwitch
LanguageEnglish

Related product manuals