Siemens SCALANCE XR-300WG - No Ip Igmp Snooping Querier

8.3.1.2 no ip igmp snooping querier
Description
With this command, you delete the configuration of an IGMP snooping switch as querier.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip igmp snooping querier
Result
The configuration of the IGMP snooping switch as querier is deleted.
Further notes
You configure the setting with the ip igmp snooping querier command.
You can display the status of this function and other information with the show ip igmp
snooping command.
Layer 2 management protocols
8.3 IGMP querier
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
388 Configuration Manual, 07/2017, C79000-G8976-C361-06