Siemens SCALANCE XR-300WG - No Poe Custom Maxpwr

poe custom maxpwr <integer(0-30)>
The parameter has the following meaning:
Parameter Description Range of values / note
integer Value for the user-defined maximum pow‐
er in watts
0 ... 30
Result
The maximum power is set.
Further notes
You enable the user-defined maximum power for the interface with the poe custom maxpwr
active command.
You disable the user-defined maximum power for the interface with the no poe custom
maxpwr active command.
You delete the user-defined maximum power for the interface with the no poe custom
maxpwr command.
3.5.3.4 no poe custom maxpwr
Description
With this command, you delete the user-defined maximum power for a port.
Requirement
You are in the Interface Configuration mode of a PoE interface.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no poe custom maxpwr
Result
The user-defined maximum power is deleted.
Configuration
3.5 PoE
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 115