Siemens SCALANCE XR-300WG - Snmp Engineid Migrate; No Snmp Engineid Migrate

Result
The details of an SNMP community are deleted.
Further notes
You configure the details of an SNMP community with the snmp community index
command.
You show the details of an SNMP community with the show snmp community command.
You show the status information of the SNMP communication with the show snmp command.
7.5.2.8 snmp engineid migrate
Description
With this command, you enable the SNMPv3 user migration.
If the function is enabled, an SNMP engine ID is generated that can be migrated. You can
transfer configured SNMPv3 users to a different device. If you enable this function and load
the configuration of the device on another device, configured SNMPv3 users are retained.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
snmp engineid migrate
Result
The SNMPv3 user migration is enabled.
Further notes
You disable the SNMPv3 user migration with the no snmp engineid migrate command.
7.5.2.9 no snmp engineid migrate
Description
With this command, you disable the SNMPv3 user migration.
Network protocols
7.5 SNMP
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
336 Configuration Manual, 07/2017, C79000-G8976-C361-06