cli(config-qos)#
Syntax
Call the command without parameters:
no agent-priority
Result
The priority of agent frames has been reset to the default value.
Further notes
You change the priority of agent frames with the agent-priority command.
You display the current priority of agent frames with the show qos agent-priority
command.
You configure the assignment of the CoS priority to a queue with the cos-map command.
10.5.3.3 broadcast-priority
Description
With this command you specify the priority of broadcast frames. The switch sorts incoming
frames into a queue according to this prioritization .
Requirement
You are in the QOS configuration mode.
The command prompt is as follows:
cli(config-qos)#
Syntax
Call up the command with the following parameters:
broadcast-priority <integer (0-7)>
The parameter has the following meaning:
Parameter Description Range of values / note
integer Value of the priority 0 … 7
Result
The priority of broadcast frames is configured.
Load control
10.5 Service classes
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
486 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
