If optional parameters are not specified when configuring a community, the default values
apply.
Note
Community string
For security reasons, do not use the standard values "public" or "private". Change the
community strings following the initial installation.
The recommended minimum length for community strings is 6 characters.
Result
The settings are configured.
Further notes
You delete the details of an SNMP community with the no snmp community index
command.
You show the details of an SNMP community with the show snmp community command.
You show the status information of the SNMP communication with the show snmp command.
7.5.2.7 no snmp community index
Description
With this command, you delete the details of an SNMP community.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no snmp community index <CommunityIndex>
The parameter has the following meaning:
Parameter Description Range of values / note
CommunityIndex Name of the community max. 32 characters
Network protocols
7.5 SNMP
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 335
To Next Page
Loading...
Need help?
General