Result
The status and the configuration of the selected interfaces are displayed.
3.1.1.9 show interfaces ... counters
Description
This command shows the counters of one, several or all interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show interfaces
[{<interface-type><interface-id>]|{vlan<vlan-
id(1-4094)>}]counters
The parameters have the following meaning:
Parameter Description Range of values / note
interface-type Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
vlan Keyword for a VLAN connection -
vlan-id Number of the addressed VLAN 1 ... 4094
For information on identifiers of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available counters.
Result
The counters of the selected interfaces are displayed.
Configuration
3.1 System
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 53
To Next Page
Loading...
Need help?
General