EasyManua.ls Logo

Siemens SCALANCE XR-300WG - No Ip Dhcp Relay Remote-ID

Siemens SCALANCE XR-300WG
618 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Requirement
The interface is an IP interface.
You are in the Interface Configuration mode of VLAN. The command prompt is as follows:
cli(config-if-vlan-$$)#
Syntax
Call up the command with the following parameters:
ip dhcp relay remote-id <remote-id name>
The parameter has the following meaning:
Parameter Description Range of values / note
remote-id name Device ID max. 32 characters
Default: XYZ
Result
The device ID is specified.
Further notes
You remove the device ID with the no ip dhcp relay remote-id command.
You display the IP addresses with the show dhcp server command.
You display the settings with the show ip dhcp relay information command.
7.4.3.4 no ip dhcp relay remote-id
Description
With this command, you remove the device identifier.
Requirement
The interface is an IPv4 interface.
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ip dhcp relay remote-id
Network protocols
7.4 DHCP Relay
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
320 Configuration Manual, 07/2017, C79000-G8976-C361-06

Table of Contents

Related product manuals