Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no shutdown
Result
The Interface is activated.
Further notes
You deactivate the interface with the shutdown command.
You can display the status of this function and other information with the show
interfacescommand.
3.1.10.16 speed
Description
With this command, you configure the transmission speed of an interface.
Note
Availability of this function
The transmission speed can only be configured for electrical data transfer.
On optical connections, the transmission speed is fixed.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
speed {10|100}
Configuration
3.1 System
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 87
To Next Page
Loading...
Need help?
General