Siemens SCALANCE XR-300WG - No Cos-Remap; Cos-Remap-Enable

10.5.3.7 no cos-remap
Description
With this command, you reset the send priority back to the default value.
Requirement
You are in the QOS configuration mode.
The command prompt is as follows:
cli(config-qos)#
Syntax
Call the command without parameters:
no cos-remap
Result
The send priorities are reset to the default value.
Further notes
You change the send priority depending on the priority when receiving a frame with the cos-
remap command.
You enable the the CoS reassignment with the cos-remap-enable command.
You disable the the CoS reassignment with the no cos-remap-enable command.
You display the assignment table for the send priority with the show qos cos-remap
command.
10.5.3.8 cos-remap-enable
Description
With this command, you enable the CoS reassignment function. Depending on the priority
when receiving a frame, you can change the priority with which it is sent.
Requirement
You are in the QOS configuration mode.
The command prompt is as follows:
cli(config-qos)#
Load control
10.5 Service classes
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
490 Configuration Manual, 07/2017, C79000-G8976-C361-06