Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
system name <system name>
The parameter has the following meaning:
Parameter Description Range of values / note
system name Input box for the name max. 255 characters
Result
The name is created in the system.
3.1.9.13 username
Description
With this command, you change the password of the factory set default user "admin".
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
username {admin} password <passwd>
Configuration
3.1 System
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
74 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
