EasyManua.ls Logo

Siemens SCALANCE XR-300WG - Mac-Address-Table Aging; No Mac-Address-Table Aging

Siemens SCALANCE XR-300WG
618 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Further notes
You configure the setting with the mac-address-table aging-time command.
You display the setting with the show mac-address-table aging-time command.
10.3.2.3 mac-address-table aging
Description
With this command, you enable the "Aging" function. The "Aging" function ensures that an
entry in the MAC address list that was learned dynamically is deleted again after a certain
time.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
mac-address-table aging
Result
The "Aging" function is enabled.
Further notes
You configure the time with the mac-address-table aging-time command.
You disable the "Aging" function with the no mac-address-table aging command.
10.3.2.4 no mac-address-table aging
Description
With this command, you disable the "Aging" function.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
Load control
10.3 Dynamic MAC aging
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
474 Configuration Manual, 07/2017, C79000-G8976-C361-06

Table of Contents

Related product manuals