6.1.4.12 no private-vlan association
Description
With this command you delete the link between secondary PVLANs and a primary PVLAN.
Requirement
● The interface is configured as a primary PVLAN.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no private-vlan association
Result
The secondary PVLANs are not assigned to the primary PVLAN.
Further notes
You assign secondary PVLANs to a primary PVLAN with the command private-vlan
association.
You display this setting with the command.
You configure a an interface as a primary PVLAN with the private-vlan command.
6.1.5 The "show" commands (Transparent Bridge)
This section describes commands with which you display various settings.
6.1.5.1 show dot1d mac-address-table
Description
This command shows the table with the static and dynamic unicast entries and the dynamic
multicast entries.
Requirement
You are in the Privileged EXEC mode.
Network structures
6.1 VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 203
To Next Page
Loading...
Need help?
General