6.3.5.9 no spanning-tree layer2-gateway-port
Description
With this command, you delete the configuration of the port as a layer 2 gateway port.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no spanning-tree layer2-gateway-port
Result
The configuration of the port as a layer 2 gateway port is deleted.
Further notes
You configure a port as a layer 2 gateway port with the commandspanning-tree layer2-
gateway-port.
You can display other information with the show spanning-tree interface command
with the detail option.
6.3.5.10 spanning-tree loop-guard
Description
This function prevents alternative ports or root ports becoming designated ports if there is a
disruption of a one-way link.
With this command, you enable the function.
Requirement
● Spanning tree is enabled.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Network structures
6.3 Spanning Tree
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 249
To Next Page
Loading...
