EasyManua.ls Logo

Siemens SCALANCE XR-300WG - No Ip Dhcp Config-File-Request; Ip Dhcp Client Mode

Siemens SCALANCE XR-300WG
618 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Further notes
You disable the DHCP config file request option with the no ip dhcp config-file-
request command.
7.2.2.2 no ip dhcp config-file-request
Description
With this command, you disable the DHCP config file request option.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip dhcp config-file-request
Result
The DHCP config file request option is disabled.
Further notes
You enable the DHCP config file request option with the ip dhcp config-file-
request command.
7.2.2.3 ip dhcp client mode
Description
With this command, you configure the type of identifier with which the DHCP client logs on
with its DHCP server.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Network protocols
7.2 DHCP client
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
284 Configuration Manual, 07/2017, C79000-G8976-C361-06

Table of Contents

Related product manuals