7.6.2.1 smtp-server
Description
With this command, you configure an entry for an SMTP server.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
smtp-server {ipv4 <ucast_addr>} <receiver mail-address>
The parameters have the following meaning:
Parameter Description Range of values
ipv4 Keyword for an IPv4 address -
ucast_addr Value for an IPv4 unicast address Enter a valid IPv4 unicast address.
receiver mail-
address
Name of the recipient max. 100 characters
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
An entry for the SMTP server is configured.
Further notes
You delete an SMTP server entry with the no smtp-server command.
7.6.2.2 no smtp-server
Description
With this command, you delete an SMTP server entry.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
Network protocols
7.6 SMTP client
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 353
To Next Page
Loading...
Need help?
General