Syntax
Call the command without parameter assignment:
no authorized-manager
Result
The authorized manager is deactivated.
Further notes
You enable the function with the authorized-manager command.
11.3.2.3 authorized-manager ip-source
Description
With this command, you configure the interfaces and protocols via which an authorized
manager is allowed to access the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
authorized-manager ip-source <ip-address>
[{<subnet-mask>|/<prefixlength(0-32)>}]
[interface[<interface-type><0/a-b,0/c,...>]
[<interface-type><0/a-b,0/c,...>]]
[vlan<a,b or a-b or a,b,c-d>]
[service[snmp][telnet][http][https][ssh]]
The parameters have the following meaning:
Parameter Description Range of values / note
ip-address Specifies the network or the IP address
for which the IP manager is authorized
Enter a valid IPv4 address or a
network.
subnet-mask Subnet mask that restricts the authori‐
zation
Enter a valid mask.
prefixlength Decimal representation of the mask as
a number of "1" bits
0 ... 32
interface Keyword for a an interface description -
Security and authentication
11.3 Management Access Control List
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
514 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General