EasyManuals Logo

Siemens SCALANCE XR-300WG User Manual

Siemens SCALANCE XR-300WG
618 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #384 background imageLoading...
Page #384 background image
Further notes
You can reset the setting to the default with the no ip igmp snooping port-purge-
interval command.
You can display the status of this function and other information with the show ip igmp
snooping globals command.
8.2.2.7 no ip igmp snooping port-purge-interval
Description
With this command, you reset the setting for the purge time to the default value.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip igmp snooping port-purge-interval
Result
The purge time is reset to the default value.
Further notes
You configure the setting with the ip igmp snooping port-purge-interval command.
You can display the status of this function and other information with the show ip igmp
snooping globalscommand.
8.2.3 Commands in the VLAN configuration mode
This section describes commands that you can call up in the VLAN Configuration mode.
In the Global Configuration mode, enter the vlan $$$ command to change to this mode.
When doing this, you need to replace the $$$ placeholders with the relevant VLAN ID.
Layer 2 management protocols
8.2 IGMP snooping
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
384 Configuration Manual, 07/2017, C79000-G8976-C361-06

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SCALANCE XR-300WG and is the answer not in the manual?

Siemens SCALANCE XR-300WG Specifications

General IconGeneral
BrandSiemens
ModelSCALANCE XR-300WG
CategorySwitch
LanguageEnglish

Related product manuals