The parameters have the following meaning:
Parameter Description Range of values / note
mst Keyword for a Multiple Spanning Tree
instance
-
instance-id Number of the instance 1 ... 64
Result
The priority of the device is reset to the default value.
Further notes
You configure the setting with the spanning-tree priority command.
You display this setting and other information with the commands that start with show
spanning-tree ....
6.3.4.12 spanning-tree passive-listening-compatibility
Description
With this command you enable the "Enhanced Passive Listening Compatibility" function.
If you enable the "Enhanced Passive Listening Compatibility" function, the IE switch sends
topology change frames via the (R)STP edge port that caused the topology change.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
spanning-tree passive-listening-compatibility
Result
The "Enhanced Passive Listening Compatibility" function is enabled.
Further notes
You disable the function with the no spanning-tree passive-listening-
compatibility command.
Network structures
6.3 Spanning Tree
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 237
To Next Page
Loading...
Need help?
General