Syntax
Call up the command with the following parameters:
set dot1x mac-auth mac-addr count <num-of-addresses (1-100)>
The parameter has the following meaning:
Parameter Description Range of values / note
num-of-addresses Maximum number of devices 1 ... 100
Result
The maximum number of devices for the port has been specified.
Further notes
You display this setting and other information with the show dot1x command.
11.5.3.13 dot1x port-control
Description
With this command, you configure port control parameter of the authenticator.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
dot1x port-control {auto|force-authorized|force-unauthorized}
The parameters have the following meaning:
Parameter Description Range of values / note
auto Authentication according to IEEE
802.1x is enabled for the interface.
The data traffic via the interface is per‐
mitted or blocked depending on the au‐
thentication result.
-
force-authorized data traffic via the interface is permitted
without restrictions
Default: force-authorized en‐
abled
force-
unauthorized
data traffic via the interface is blocked -
Security and authentication
11.5 Port Based Network Access Control
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 537
To Next Page
Loading...
