Siemens SCALANCE XR-300WG - Configuration Save & Restore; The Show Commands; Show Running-Config

3.4 Configuration Save & Restore
This section describes commands for displaying, saving and restoring configuration settings.
3.4.1 The "show" commands
This section describes commands with which you display various settings.
3.4.1.1 show running-config
Note
The IE switch does not support all parameters, refer to the section "Features not supported
(Page 30)".
Description
This command shows configuration settings of the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show running-config
[{
syslog|dhcp|qos|stp|la|dot1x|vlan<vlan-id(1-4094)>|
interface
{port-channel<port-channel-id(1-8)>|
<interface-type><interface-list>|
vlan<vlan-id(1-4094)>
}|
ssh|ssl|acl|ip|snmp|radius|rmon|igmp|sntp|http|
broadcast-blocking|multicast-blocking|locked-port|auto-logout|
time|ntp|auto-save|panel-button|cos-map|dscp-map|
output-rate-limit|unicast-blocking|ospf|vrrp|loopd|events|
redundancy|passive|umac|nat|fmp|pim|router-advertisement-
blocking}]
[all]
Configuration
3.4 Configuration Save & Restore
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
104 Configuration Manual, 07/2017, C79000-G8976-C361-06