Siemens SCALANCE XR-300WG - No Broadcast-Priority; Cos-Map

Further notes
You reset the priority of broadcast frames to the default value with the no broadcast-
priority command.
You display the current priority of broadcast frames with the show qos broadcast-
priority command.
You configure the assignment of the CoS priority to a queue with the cos-map command.
10.5.3.4 no broadcast-priority
Description
With this command, you reset the priority of broadcast frames back to the default value.
Requirement
You are in the QOS configuration mode.
The command prompt is as follows:
cli(config-qos)#
Syntax
Call the command without parameters:
broadcast-priority
Result
The priority of broadcast frames has been reset to the default value.
Further notes
You change the priority of broadcast frames with the broadcast-priority command.
You display the current priority of broadcast frames with the show qos broadcast-
priority command.
You configure the assignment of the CoS priority to a queue with the cos-map command.
10.5.3.5 cos-map
Description
With this command, you configure the assignment of CoS priorities to queues.
Load control
10.5 Service classes
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 487