Type of interface Command prompt
fast-ethernet cli(config-if-Fa$-$)#
gigabitethernet cli(config-if-Gi$-$)#
The placeholders $ or $-$ denote the numbering of the interface.
The ranges of values for the logical interface VLAN and port channel can be found in the table
above. You can only call up interfaces that you created with the vlan or channel-group
command.
The ranges of values from the physical interfaces depend on the hardware configuration.
Further notes
You exit the Interface configuration mode with the end or exit command.
You delete a logical interface with the no interface command.
You display the status and the configuration of the interfaces with the show interfaces
command.
See also
Features not supported (Page 30)
3.1.9.2 no interface
Description
With this command, you delete a logical interface.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no interface{vlan<vlan-id(1-4094)>|port-channel<port-channel-
id(1-8)>}
The parameters have the following meaning:
Parameter Description Range of values / note
vlan Keyword for a VLAN connection -
vlan-id Number of the addressed VLAN 1 … 4094
Configuration
3.1 System
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
66 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General