10.3 Dynamic MAC aging
The section describes commands with which the aging of dynamically learned entries is
configured in a MAC address list.
10.3.1 The "show" commands
This section describes commands with which you display various settings.
10.3.1.1 show mac-address-table aging-time
Description
To ensure that the address entries are up-to-date, MAC addresses are only kept in the address
table for a specified time.
This command shows the time after which the MAC addresses are removed from the address
table.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show mac-address-table aging-time
Result
The time is displayed.
10.3.1.2 show mac-address-table aging-status
Description
This command shows whether or not MAC aging is enabled.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
Load control
10.3 Dynamic MAC aging
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 471
To Next Page
Loading...
Need help?
General