6.2.1.2 show interfaces etherchannel
Description
This command shows the interface-specific information for a port channel.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show interfaces[<interface-type><interface-id>]etherchannel
The parameters have the following meaning:
Parameter Description Range of values / note
interface-type Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select an interface, information for all interfaces is displayed.
Result
The interface-specific information for a port channel is displayed.
Note
When a port is assigned to a link aggregation but is not active (e.g. link down), the values
displayed may differ from the values configured for the link aggregation.
If the port in the link aggregation becomes active, individual port configurations such as DCP
forwarding are overwritten with the configured values of the link aggregation.
6.2.1.3 show lacp
Description
This command shows the information about the settings and information about the ports
involved in the link aggregation. The number of sent and received packets is also displayed.
Network structures
6.2 Link aggregation
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
214 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General