9.1.3.8 no ip nat service
Description
With this command you delete static port translations (NAPT) for an interface with a service.
Requirement
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
no ip nat service {{<inside local ip> <inside local port number>
[{ tcp | udp | any }]} | all}
The parameters have the following meaning:
Parameter Description Range of values / note
inside local ip Actual address of the device that
is reachable from external.
Enter a valid IPv4 address.
inside local port
number
Port that is assigned to the inside
local address.
-
Protocol Protocol for which the port transla‐
tion is valid.
● tcp
● udp
● any
all Deletes all port translations -
Result
The static port translation with a service is deleted.
Further notes
You configure static port translations with a service for an interface with the ip nat
service command.
You configure static port translations for an interface with a port range with the ip nat
service portrange command.
You display the current configuration with the show ip nat service command.
Layer 3 functions
9.1 NAT
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 445
To Next Page
Loading...
