Syntax
Call the command without parameters:
show linkcheck
Result
The current information is displayed.
8.4.4.3 show ring-redundancy
Description
With this command, you show the current configuration of the ring redundancy and standby
functions.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ring-redundancy
Result
The current configurations are displayed.
8.4.4.4 show ring-redundancy manager counters
Description
With this command, you display the following information:
● How often the device as redundancy manager switched to the active status, i.e. opened its
blocked port because it no longer receives its sent RM frames.
● The maximum delay time of the test frames of the redundancy manager.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
Layer 2 management protocols
8.4 Ring redundancy and standby connection
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 393
To Next Page
Loading...
Need help?
General