Result
The details of the SNMP notifications are deleted.
Further notes
You change the details of an SNMP group with the snmp notify command.
You display the configured SNMP notifications with the show snmp notif command.
You display the configured SNMP target addresses with the show snmp targetaddr
command.
7.5.2.14 snmp targetaddr
Description
With this command, you configure the SNMP target address.
Requirement
● The SNMP target parameters are configured.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp targetaddr <TargetAddressName> param <ParamName>
{ipv4<IPAddress>}
[timeout <Seconds(1-1500)] [retries <RetryCount(1-3)]
[taglist <TagIdentifier | none>] [{volatile | nonvolatile}]
[port <integer (1-65535)>]
The parameters have the following meaning:
Parameter Description Range of values
TargetAddressName Name of the target address max. 32 characters
param Keyword for the parameter name -
ParamName Name of the destination address or
the designation of the parameter
name
max. 32 characters
ipv4 Keyword for an IPv4 address -
IPAddress Value for an IPv4 unicast address Enter a valid IPv4 unicast address.
timeout Keyword for the time the SNMP agent
waits for a response before it repeats
the inform request message
-
Network protocols
7.5 SNMP
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 341
To Next Page
Loading...
Need help?
General