3.1.1.13 show lldp status
Description
This command shows per port whether LLDP frames are sent or received.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show lldp status [port {<interface-type> <interface-id>}]
The parameters have the following meaning:
Parameter Description Range of values/note
port Keyword for a port description. -
interface-type Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
For information on identifiers of interfaces and addresses, refer to the section "Addresses and
interface names (Page 36)".
Result
The information is displayed.
3.1.1.14 show broadcast-block config
Description
This command shows the broadcast blocking settings for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Configuration
3.1 System
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
56 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
