6.2 Link aggregation
This section describes commands that configure or manage the bundling of interfaces or
connections between devices.
6.2.1 The "show" commands
This section describes commands with which you display various settings.
6.2.1.1 show etherchannel
Description
This command shows the settings of the Etherchannel.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show etherchannel [[channel-group-number]
{detail|load-balance|port|port-channel|summary|protocol}]
The parameters have the following meaning:
Parameter Description
channel-group-
number
Number of the Channel-Group
detail Detailed display of the settings
load-balance Shows which load balancing method is enabled
port Information on the Etherchannel port
port-channel Information on the Port-Channel
summary Brief overview of the settings of a Channel-Group
protocol Specification of the protocol set for a Channel-Group
If you do not select any parameters from the parameter list, the settings of all channels will be
displayed in detail.
Result
The Etherchannel settings are displayed.
Network structures
6.2 Link aggregation
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 213
To Next Page
Loading...
Need help?
General