Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show vlan device info
Result
The global information is displayed.
6.1.6 Commands in the global configuration mode (Transparent Bridge)
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
6.1.6.1 base bridge-mode
Description
With this command, you configure whether or not the device forwards frames with VLAN tags
transparently (IEEE 802.1D/Transparent Bridge) or takes VLAN information into account (IEEE
802.1Q/VLAN Bridge).
Note
Changing base bridge mode
Note the section "Changing base bridge mode". This section describes how a change affects
the existing configuration.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
Network structures
6.1 VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 207
To Next Page
Loading...
Need help?
General