8.2.2.1 ip igmp snooping version
Description
This command specifies which version of IGMP snooping the device will use. When shipped,
the device uses IGMPv3.
Note
There is no separate show command to display the version of IGMP used by the device. This
information is shown when you enter the show ip igmp snooping command in the User
EXEC mode or in the Privileged EXEC mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip igmp snooping version {v1 | v2 | v3}
The parameters have the following meaning:
Parameter Description
v1 IGMPv1
v2 IGMPv2
v3 IGMPv3
Result
The version of IGMP snooping used by the device is specified.
8.2.2.2 ip igmp vlan-snooping
Description
With this command, you enable IGMP snooping for all VLANs.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
Layer 2 management protocols
8.2 IGMP snooping
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
380 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General