Siemens SCALANCE XR-300WG - Show Ip Igmp Snooping Statistics

The command prompt is as follows:
cli#
Syntax
Call up the command with the following parameters:
show ip igmp snooping mrouter [Vlan <vlan index>] [detail]
The parameters have the following meaning:
Parameters Description Range of values
Vlan Keyword for a VLAN or VLAN range -
vlan index Number of the addressed VLAN or VLAN range 1 ... 4094
detail Specifies that detailed information is displayed. -
Result
A list of the active ports is displayed.
8.2.1.6 show ip igmp snooping statistics
Description
This command shows the statistical information about IGMP snooping for all or a selected
VLAN.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show ip igmp snooping statistics [Vlan<vlan id>]
The parameters have the following meaning:
Parameter Description Range of values / note
Vlan Keyword for a VLAN connection -
vlan id Number of the addressed VLAN 1 ... 4094
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Layer 2 management protocols
8.2 IGMP snooping
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
378 Configuration Manual, 07/2017, C79000-G8976-C361-06