Siemens SCALANCE XR-300WG - Show Ip Nat Service Portrange; Show Ip Nat Summary

9.1.1.3 show ip nat service portrange
Description
This command shows static port translations (NAPT) for an interface with a port range.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show ip nat service portrange
Result
The selected service, start and end port of an interface are displayed.
Further notes
You configure static port translations for an interface with a port range with the ip nat
service portrange command.
You delete a configuration with the no ip nat service portrange command.
9.1.1.4 show ip nat summary
Description
This command shows the NAT/NAPT configuration of the interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show ip nat summary
Layer 3 functions
9.1 NAT
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
434 Configuration Manual, 07/2017, C79000-G8976-C361-06